Geoengineering - Climate Change Mitigation

Design Desk Inc.

"Z" GEN
 
COMPONENT "ZH" (OIL) , OR COMPONENT "Z" (PNEUMATIC PRESSURE) ....  UPON THE OIL JACKER HTML.   THEN TO ROTATE PRESSURE AIR OR OIL WITHIN A TORIOD WITH 90 DEGREE ,INTERSECTING OF FLOW , TRANSVERSE , IMPELLER ( TRANSONIC TYPE / LIKE A PROPELLER ).

THEN IMPELLER  THEN DRIVING A DRIVE SHAFT CONNECTED TO A RATIO GEAR SET WITH THE ROTATIONAL RESISTANCE FROM GEAR SET AMPLIFICATION THEN COUNTER ACTED UPON BY HYDRAULIC OR PNEUMATIC FLOW CAUSED BY PRESSURE  ( RE-DUMPS TO LOW PRESSURE POINT WITHIN THE DESIGN WITHIN THE SAME PRESSURE TYPE,  TO THEN CAUSE AN AUTOMATIC TRANSMISSION ( OPTIONAL ) TO THEN ROTATE SPINNING A GENERATOR PERMANENT MAGNETIC.

  THE GENERATOR IS ALSO THEN CONNECTED TO AN IMPELLER CENTRIFUGAL TYPE TO THEN COUNTERACT THE RESISTANCE OF MAGNETIC FIELDS PRODUCED WHILE GENERATING BY FLUID OR PNEUMATIC FLOW TO THEN VENT POST SAID IMPELLER TO THE LOW PRESSURE POINT WITHIN THE SYSTEM ..

OF THE SAME PRESSURE MASS PNEUMATIC OR HYDRAULIC. THE SYSTEM MAY COMBINE BOTH OIL AND AIR PRESSURE FOR THE COUNTERACTING EFFECTS REQUIRED FOR CONTINUAL OPERATION . COIL SPRING TENTIONED MAY START THE SYSTEM ROTATING .

ELECTRICITY THEN REGULATED  BY VOLTAGE REGULATOR AND  POTENTIOMETER TO THEN BE RE APPLIED TO THE ELECTRIC MOTOR THAT HAS THEN BEEN PRODUCED BY THE PERMANENT MAGNETIC GENERATOR WITH COMPOUNDING FIELD COIL / STATOR. 

A SECONDARY LOW PRESSURE TANK BAY BE REQUIRED TO CYCLE THE IMPELLER DISPLACEMENT WITH AN ELECTRIC  CIRCULATION PUMP TO EVACUATE THE ADDITIONAL  LOW PRESSURE PRESSURE TANK TO
PREPARE FOR THE NEXT RESTART.

Type your paragraph here.